HERMOS LFM 4x - E - Error Message

HERMOS AG
Gartenstraße 19 • 95490 Mistelgau
Phone: +49 9279 991 - 0
E-mail: rfid@hermos.com
LFM 4x Reader Rev1.4
back to the table of contents
54
www.hermos.com
Customer manual
LFM 4x Reader
RFID
WE GENERATE SOLUTIONS
10.4.8 e – Error message
This message is only available in standard ASC-I1 mode!
If an error occurs the device will send an error message with the respective error code.
Device  Host
CMD
Reader-ID
Error ID
e
1 Byte
1 Byte
Further information about error codes and the corresponding corrective measures can be found
in the chapter Error Codes.
10.4.9 E – Error message
This message is only available in ASC-W1 mode. If there is an error, the device sends an error
messa- ge with the appropriate error code to the host.
The reader expects a confirmation of the error message. If there is no confirmation from the
host, the command is repeated. (Par.5: ‚RS232 delay time‘, par.6: ‚RS232 maxrepeat‘).
Device  Host
CMD
Reader-ID
Error ID
E
1 Byte
1 Byte
More about error codes and the corresponding corrective measures can be found in the
chapter Error Codes.
Host  Device
CMD
Reader-ID
e
1 Byte