8
6. Power ON/OFF
6.1 Battery and Charging
When turning on the analyzer for the rst time after unpacking, please
connect the adapter for power supply and turn off the transportation
mode. You do not need to repeat this operation for subsequent reboot.
Ensure the analyzer is fully charged (Approximately 3.5 hours to fully
charge) before using for the rst time.
When the screen displays E001, the adapter should be connected
immediately for charging. If the battery charge display shows only one bar,
it is recommended that the user connect the power adapter to charge as
soon as possible.
When the analyzer automatically shuts down due to insufcient power, the
user should charge the analyzer within 7 days. Otherwise the time and
date will require a reset.
The test results and all settings of the analyzer will be permanently stored
in the memory except the time and date.
6.2 Power ON
When the instrument is turned on for the rst time, the battery must be
fully charged. If the battery is low, do not turn the instrument on until the
power adapter provided with the instrument is inserted into the power jack
and connected to the external power supply. If the instrument is in power
off mode, short press the Power button and wait 2 seconds to power on.
If the instrument is in sleep mode, short press the Power button or insert a
test strip and wait 2 seconds to wake it up.
If Operator ID is set to On, the
analyzer automatically enters
Operator ID menu (Figure 1-1)
after it is turned on. Manually input
Operator ID and Password or obtain
by scanning (The default Operator
ID is "admin" and all must be
lower case. The default password
is "123456".) and touch “ ” to
enter main menu.
Please set Operator ID function
according to Section 7.7 of this
manual.
1-1
To Next Page
Loading...