1
1. Introduction
1.1 Before Starting
Before using the Element COAG+ Analyzer, carefully read the Product
Manual as well as the package inserts for all relevant consumables.
1.2 Intended Use
The Element COAG+ Analyzer system, which consists of Element COAG+
Test Strips, is intended for quantitative determination of Prothrombin Time
(PT) and Activated Partial Thromboplastin Time (aPTT) in fresh venous
blood and citrated whole blood. The Element COAG+ Analyzer is only for
veterinary use in cat, dog and other animals.
1.3 Test Principle
The Element COAG+ Analyzer automatically detects the insertion of a test
strip and heats the strip to a preset operating temperature. After a drop
of blood is applied to the strip, the sample channel automatically carries
the blood sample into the reaction zone through capillary action, where
the blood mixes with pre-printed reagent and starts coagulation process.
As the blood coagulates, conductivity across the test strip changes. The
system measures this electrical change and calculates the development of
a clot. The values are then displayed.
1.4 Packaging
The Element COAG+ Analyzer is packed individually. Upon receipt of the
device, please open and remove the packaging materials, then place
the Element COAG+ Analyzer on a at surface and connect the power
adapter to make it ready for testing.
Do not keep the Element COAG+ Analyzer in direct sunlight, near a high
heat source, or near an area with a strong magnetic eld.
If you nd any damage that may be caused by transportation, please
inform Heska's Technical Support Services.
Please pay attention to content where the symbol “ ” appears in the
manual.
To Next Page
Loading...