HEX GS-911 - Page 19

Hex GS-911 for BMW Motorcycles
_________________________________________________________________________________________________
_________________________________________________________________________________________________
© Hex Innovate 2021-2022 Page 19 of 38 GS-911 2207.2
2. Place the GS-911 where it cannot be damaged.
3. Prepare the motorcycle for diagnostics by doing the steps that
follow:
i. Turn on the ignition switch and the kill switch.
ii. Make sure the gearbox is in the Neutral (N) position.
iii. Make sure the sidestand is in the down position.
iv. If you are going to do service functions, connect an
intelligent battery charger to the motorcycle’s battery.
CAUTION
Do not place the GS-911 on hot surfaces, engine
components, near moving parts, or where it could be
exposed to hot exhaust, oil or petrol (gasoline).
Do not strain the wires leading from the BMW diagnostic
connector. This could lead to circuit breaks and cause the
motorcycle’s electronic systems to malfunction.
Extension cables are available, and can be used to place
the GS-911 in a safe location while it is being used. See
GS-911 extension cables for details.