Troubleshooting Page 5-16
L000950, Version: 4.0 February 2016
Laminator Film Break/Jam
A Film break/jam has been
detected inside the Laminator.
The printer has determined that one or both
overlaminate films have either jammed or broken.
Open the Laminator Cover and remove the
Laminator Cartridge(s). If overlaminate is jammed,
remove jam and tighten the material.
Clear any cards in the printer by using the Forward
and/or Back buttons located on the Printer's LCD
display.
Tape the ends of the overlaminate together and
wind any excess onto the Take-up Spool of the
Overlaminate.
Re-install the Laminator Cartridge(s), close the
Laminator Cover and press the Resume button
located on the Printer's LCD display to continue
printing.
To cancel the print, press the Cancel Print button
from the Driver's display dialog and the Cancel
button located on the Printer's LCD display.
Laminator Film Sensor Error
The Laminator cannot find the
next panel on the Film.
Check that the Film is installed properly and press
Resume.
To cancel, press the Cancel Print button or the
Cancel button located on the Printer.
Remove Laminator Film
To c o n t i n u e, r e m ove t he
laminator's film.
Open the Laminator's Front Cover. Remove the film
and close the Laminator's Front Cover.
Laminator Film Out
The film installed in the printer is
empty.
Install new Film and press the Resume button to
continue printing.
To cancel the print, press the Cancel Print button or
the Cancel button located on the Printer.
Laminator Film is not
Installed
No film is installed in the Printer.
Install the Film and press Resume.
To cancel the print, press the Cancel Print button or
the Cancel button located on the Printer.
Laminator Film Sensor Error
The Printer cannot find the next
panel on the Print Film.
Check that the Print Film is installed properly and
press Resume.
To cancel the print, press the Cancel Print button or
the Cancel button located on the Printer.
Wrong Laminator Film
Installed
An incorrect Print Film has been
installed, or a driver setting is
incorrect.
Ensure that the appropriate Print Film is installed
and press the Resume button located on the Printer
to continue printing.
To cancel, press the Cancel Print button or the
Cancel button located on the Printer.
Printer Error Message Cause Solution
To Next Page
Loading...
