Section 3 - Preparing the Rockpicker
217008
217009
Hitch Position 2 - Single Tractor Tires
215247
Hitch Position 1 - Dual Tractor Tires
215248
Hitch Working Positions
There are 2 possible working positions for the
hitch:
Position 1 is for tractors using dual rear tires.
- This hitch position moves the rockpicker
further to the right of the tractor (more
than Position 2) to give greater visibility of
the picking process.
- This hitch position also moves the
rockpicker out of the compression zone
left by the dual rear tractor tires.
Position 2
is for tractors using single rear
tires.
- This hitch position moves the rockpicker
to the right of the tractor (less than
Position 1) out of the compression zone
left by single rear tractor tires.
Parts on the hitch must be moved to set the
hitch for the different working positions.
- See the directions below for setting
the hitch positions.
Page 3-5
To Next Page
Loading...
