HikRobot MV-CL021-40GM - Page 50

GigE Line Scan Camera·User Manual
41
 If you need to let the camera output signals when event sources occur that are corresponding
to each line image, follow steps below to set it.
Steps:
1. Click Digital IO Control, and select Line Mode as Strobe Source Selector.
2. Set Line Source according to actual demands.
3. Enable Strobe Enable.
Figure 8-4 Set Line Mode
When selected event sources occur, one event information will be created, and the camera will
output one strobe signal at the same time. Refer to the table below for detailed event source
description.
The specific event source may differ by camera models.
Table 8-1 Event Source Description
No.
Name
Description
1
Exposure Start Active
The camera outputs signals to external devices when it starts exposure.
2
Acquisition Start Active
The camera outputs signals to external devices when it starts acquiring images.
3
Acquisition Stop Active
The camera outputs signals to external devices when it stops acquiring images.
4
Frame Burst Start Active
The camera outputs signals to external devices when frame burst starts.