HikRobot MV-CL021-40GM - Page 88

GigE Line Scan Camera·User Manual
79
 Select Off as PRNUC Target Enable if you want to use the camera’s auto correction
standard. At this time, the camera compares and corrects the average R/G/B component
value of each column with the average R/G/B component value of the entire image.
 Select On as PRNUC Target Enable if you want to manually correct, and set PRNUC Target
R, PRNUC Target G, and PRNUC Target B according to actual demands. At this time, the
camera compares and corrects the average R/G/B component value of each column with
the configured R/G/B value.
2. Click Execute in Activate Shading.
3. Enable NUC Enable, and PRNUC Enable will be enabled automatically.
Figure 10-45 Set Shading Correction (II)
For other camera models, follow steps below to operate:
Steps:
1. Click Shading Correction, select PRNUC User Selector, and the camera starts to acquire
images.
2. Set PRNUC target related parameters according to actual demands.
 Disable PRNUC Target Enable if you want to use the camera’s auto correction standard. At
this time, the camera compares and corrects the average R/G/B component value of each
column with the average R/G/B component value of the entire image.
 Enable PRNUC Target Enable if you want to manually correct. For mono cameras, set
PRNUC Target, and for color cameras, set PRNUC Target R, PRNUC Target G, and PRNUC
Target B according to actual demands. At this time, the camera compares and corrects the
average gray value or R/G/B component value of each column with the configured gray
value or R/G/B value.
3. Click Execute in Activate Shading, and enable PRNUC User Enable.