HIKVISION DS-7108HI-S Series

DS-7108HI-S series Net DVR User Manual
38
Step 3: Select sensitivity: move active frame to sensitivity item right beside the “View
tampering” item. Press [edit] key, then you can use [↑] [↓] keys to select the sensitivity for “View
Tampering” item. The sensitivity options are: Low, Normal and High. Select one of them will
active “Area Setup” and “Policy” configuration.
Step 4: View tampering area setup Move “Active Frame” to “Area” button, press [ENTER]
key to enter area setup interface. The setup methods are same as that of mask area setup. After you
setup the area, press [ENTER] key to return “Advanced settings” menu. You can press [ESC] key
to invalidate.
Only one view tampering area can be setup, and the size of the area can be full screen.
Step 5: View tampering alarm setup In “Advanced settings” menu, move “Active Frame”
to “Policy” button, press[ENTER]key to enter “View Tampering Handle” menu: Shown as
Fig.5.16 below
Fig. 5.16 View tampering handle setup
Step 6: Alarm schedule setup: When there is view tampering alarm happened, DVR will
handle the alarm based on the schedule. You can set 4 periods for each day one week. Also you
can copy the schedule of one day to other days.
Notes: Time periods can’t be repeated. Please reboot DVR to make the parameters become
effective.
Step 7: Setup alarm policy: If there is view tampering alarm happened in schedule, DVR
will response based on the policy. You can select one or more solution including “On Screen
Warning”, “Audible Warning”, “Upload to Center” and “Trigger Alarm Output”. You can use [↑]
[↓] and [EDIT] key to enable or disable them. “×” is disable and “” is enable.
Step 8: Save alarm setup: After your setup, press “Confirm” button and return “Image
Setup” interface. In “Image Setup” menu, press “Confirm” button to save current camera
parameters and return main menu.