DS-7108HI-S series Net DVR User Manual
6
Chapter2 Installation
Warning: Before you install the DVR, please make sure that the power of DVR is switched
off.
2.1 Checking the DVR and Its Accessories
When you get the product, check that all the goods are included in your product package.
There is a list in the package. If any of the goods is missing, please contact your dealer.
2.2 HDD Installation
Installation notice
Note: A factory recommended HDD should be used for this device.
There is no HDD in the DVR when leaving factory. According to the record schedule, you
can calculate the total capacity you need (refer to Appendix A). Please ask the specialist to
disassemble the DVR and install HDD.
Installation instrument
One cross screw driver
HDD installation
1. Open the DVR box.
2. Place the HDD on the mounting plate.
3. Connect the SATA data cable correctly. First put the power plug of the HDD in the
motherboard. Plug the data line of the HDD into the SATA interface.
4. Fix the HDD into the Chassis.
5. Cover and fix the DVR box.
Note: After the HDDs installation, you must format them. Please refer to chapter 6.3
To Next Page
Loading...
Need help?
General