HIKVISION DS-K1T341C Series

Steps
1.
Enter Person module.
Note
For the rst me you enter Person module, a window pops up, and you can set the rules to
generate person ID (leers and numbers supported) when adding person. When geng person
informaon from device, if there are no person IDs, the person IDs will be generated according
to the rule.
2.
Select an organizaon in the organizaon list to add the person.
3.
Click Add to open the adding person window.
The Person ID will be generated
automacally.
4.
Enter the basic informaon including person name, telephone number, email address, validity
period, etc.
5.
Conrm to add the person.
-
Click Add to add the person and close the Add Person window.
-
Click Add and New to add the person and
connue to add other persons.
9.4.3 Issue a Card by Local Mode
If a card enrollment staon is available, you can issue a card by local mode. To read the card
number, you should connect the card enrollment
staon to the PC running the client by USB
interface or COM, and place the card on the card enrollment staon.
Steps
1.
Enter Person module.
2.
Select an
organizaon in the organizaon list to add the person and click Add to enter Add
Person panel.
Note
Enter the person's basic informaon rst. For details about conguring person's basic
informaon, refer to Congure Basic Informaon .
3.
In the Credenal → Card area, click +.
4.
Click Sengs to enter the Sengs page.
5.
Select Local as the card issuing mode.
DS-K1T341C Series Face Recognion Terminal User Manual
137