HIKVISION DS-K1T341C Series - Chapter 3 Installation; 3.1 Installation Environment; 3.2 Install with Gang Box

Chapter 3 Installaon
3.1 Installaon Environment
●
Avoid backlight, direct sunlight, and indirect sunlight.
●
For
beer recognion, there should be light source in or near the installaon environment.
●
The minimum bearing weight of the wall or other places should be 3
mes heavier than the
device weight.
●
There shall be no strong
reecve objects (such as glass doors/walls, stainless steel objects,
acrylic and other glossy
plascs, lacquer, ceramic les, etc.) within 1 m of the eld of view of the
device.
●
Avoid device reecon.
●
Face recognion distance shall be greater than 30 cm.
●
Keep the camera clean.
Note
For details about installaon environment, see Tips for Installaon Environment.
3.2 Install with Gang Box
Steps
Note
The addional force shall be equal to three mes the weight of the equipment. The equipment ad
its associated mounng means shall remain secure during the installaon. Aer the installaon,
the equipment, including any associated mounng plate, shall not be damaged.
1.
Make sure the gang box is installed on the wall.
DS-K1T341C Series Face Recognion Terminal User Manual
4