HIKVISION DS-K1T341C Series

Note
If the peripheral card reader supports presenng EM card, the funcon is also supported to
enable/disable the EM card funcon.
Enable DESFire Card
The device can read the data from DESFire card when enabling the DESFire card funcon.
DESFire Card Read Content
Aer enable the DESFire card content reading funcon, the device can read the DESFire card
content.
Enable FeliCa Card
The device can read the data from FeliCa card when enabling the FeliCa card
funcon.
Set Card
Authencaon Parameters
Set the card reading content when authencate via card on the device.
Go to
Conguraon → General → Card Authencaon Sengs .
Select a card authencaon mode and click Save.
Full Card No.
All card No. will be read.
Wiegand 26 (3 bytes)
The device will read card via Wiegand 26 protocol (read 3 bytes).
Wiegand 34 (4 bytes)
The device will read card via Wiegand 34 protocol (read 4 bytes).
Congure
Authencaon Result Text
Steps
1.
Go to Conguraon → General → Authencaon Result Text .
2.
Enable Customize
Authencaon Result Text.
3.
Enter custom texts.
4.
Click Save.
8.5.19 Access Control
Sengs
Set Door Parameters
Click Conguraon → Access Control → Door Parameters .
DS-K1T341C Series Face Recognion Terminal User Manual
114