Access Control Terminal·User Manual
39
Editing Device (Door Information)
Steps:
1. In the editing interface, click the Door_1 button to edit the information of
the selected door.
1) Door Magnetic: The Door Magnetic is in the status of Remain Closed
(excluding special conditions).
2) Exit Button Type: The Exit Button Type is in the status of Remain
Open (excluding special conditions).
3) Door Locked Time(s): After swiping the normal card and relay action,
the timer for locking the door starts working.
4) Door Open for Disabled Person: The door magnetic can be enabled
with appropriate delay after disabled person swipes the card.
5) Door Open Timeout(s): The alarm can be triggered if the door has
not been close
6) Enable Lock Door when Door Close: This function has not been
supported yet.
7) Duress Code: The door can open by inputting the duress code when
there is a duress. At the same time, the access system can report the
duress event.
8) Super Password: The specific person can open the door by inputting
the super password.
2. Click the Restore Default Value to restore all parameters into default
To Next Page
Loading...
