Access Control Terminal·User Manual
68
2. Check the checkbox of the corresponding linkage actions and set the
property as Trigger to enable this function.
Host Buzzer: The audible warning of controller will be triggered.
Reader Buzzer: The audible warning of card reader will be triggered.
Alarm Output: The alarm output will be triggered for notification.
Door (Open/Close): The door will be open or closed when the case is
triggered.
3. Click the Save button.
4. Click the Apply button to take effect of the new settings.
The Door cannot be configured as open or closed at the same time.
Event Card Interact
In the Interact Configuration interface, click the Event Card Interact button to
enter the settings interface.
Event Linkage
In the Event Interact interface, the linkage alarm action, after triggering alarm
event, can be set. The alarm event can be divided into four types: event device,
event input alarm, door event, and card reader event.
Steps:
1. Click the button to enter the event card interface
2. Select the host to be set from the host list.