HIKVISION DS-TCL400-E - Page 43

The device automacally gets the IPv4 parameters from the network if you check Auto-
Obtain. The device IP address is changed aer enabling the funcon. You can use SADP to get
the device IP address.
Note
The network that the device is connected to should support auto-obtain.
Manual
You can set the device IPv4 parameters manually. Enter IPv4 Address, IPv4 Subnet Mask, and
IPv4 Default Gateway.
IPv6
Three IPv6 modes are available.
Route Announcement
The IPv6 address is generated by combining the route announcement and the device Mac
address.
Note
Route announcement mode requires the support from the router that the device is connected
to.
Auto-Obtain
The IPv6 address is assigned by the server, router, or gateway.
Manual
Enter IPv6 Address, IPv6 Subnet Mask, and IPv6 Default Gateway. Consult the network
administrator for required
informaon.
MTU
It stands for maximum transmission unit. It is the size of the largest protocol data unit that can
be communicated in a single network layer transacon.
The valid value range of MTU is 1280 to 1500.
Mulcast Address
Mulcast is group communicaon where data transmission is addressed to a group of
desnaon devices simultaneously. Aer seng the IP address of the mulcast host, you can
send the source data
eciently to mulple receivers.
DNS
It stands for domain name server. It is required if you need to visit the device with domain
name. And it is also required for some applicaons (e.g., sending email). Set Preferred DNS
Server properly if needed.
Smart On-Street ANPR Camera User Manual
29