HIKVISION DS-TCL400-E - Set DST; Export Parameters; Import Configuration File

Select it to synchronize the device me with that of the NTP server. Set Server Address, NTP
Port, and Interval. Click NTP Test to test if the connecon between the device and the server
is normal.
Manual Synchronizaon
Select it to synchronize the device me with that of the computer. Set me manually, or
check Sync. with computer me.
Note
The me synchronizaon modes vary with dierent models. The actual device prevails.
4.
Click Save.
11.7 Set DST
If the region where the device is located adopts Daylight Saving Time (DST), you can set this
funcon.
Steps
1.
Go to Conguraon → Device Conguraon → System Conguraon → DST .
2.
Check Enable DST.
3.
Set Start Time, End Time, and DST Bias.
4.
Click Save.
11.8 Export Parameters
You can export the parameters of one device, and import them to another device to set the two
devices with the same parameters.
Steps
1.
Go to
Conguraon → Device Conguraon → System Maintenance → Export Conguraon
File .
2.
Click Export.
3.
Set a password, and click OK.
Note
The password is used for imporng the conguraon le of the current device to other devices.
4.
Select the saving path, and enter the le name.
5.
Click Save.
11.9 Import
Conguraon File
Import the conguraon le of another device to the current device to set the same parameters.
Smart On-Street ANPR Camera User Manual
41