HIKVISION DS-TCL400-E - Reboot; Restore Parameters; Synchronize Time

4.
Click OK in the popup window.
Note
The upgrade process will take 1 to 10 minutes. Do not cut o the power supply.
Result
The device will reboot automacally aer upgrade.
11.4 Reboot
When the device needs to be rebooted, reboot it via the soware instead of cung o the power
directly.
Steps
1.
Go to
Conguraon → Device Conguraon → System Maintenance → Reboot .
2.
Click Reboot.
3.
Click OK to reboot the device.
11.5 Restore Parameters
When the device is abnormal caused by the incorrect set parameters, you can restore the
parameters.
Steps
1.
Go to
Conguraon → Device Conguraon → System Maintenance → Default .
2.
Select the restoraon mode.
-
Click Restore to restore the parameters except the IP address, subnet mask, gateway, and port
No. to the default sengs.
-
Click Default to restore all the parameters to the factory sengs.
3.
Click OK.
11.6 Synchronize Time
Synchronize the device me when it is inconsistent with the actual me.
Steps
1.
Go to Conguraon → Device Conguraon → System Conguraon → Time Sengs .
2.
Select Time Zone.
3.
Select
Synchronizaon Mode.
NTP Synchronizaon
Smart On-Street ANPR Camera User Manual
40