HIKVISION DS-TCL400-E - Page 48

Figure 8-2 Set RS-232
3.
Set Baud Rate, Data Bit, Stop Bit, etc.
Note
The parameters should be same with those of the connected device.
4.
Select Working Mode.
Console
Select it when you need to debug the device via RS-232 serial port.
Transparent Channel
Select it, and the network command can be
transmied to RS-232 control command via the
RS-232 serial port.
Narrowband
Reserved.
5.
Click Save.
Smart On-Street ANPR Camera User Manual
34