Network Video Recorder User Manual
109
Chapter 9 Network Settings
Configuring General Settings
Purpose:
Network settings must be properly configured before you operate NVR over network.
Go to Menu > Configuration > Network > General.
Network Settings
Configure the following settings: Working Mode, NIC Type, IPv4 Address, IPv4
Gateway, MTU and DNS Server.
If the DHCP server is available, you can click the checkbox of DHCP to
automatically obtain an IP address and other network settings from that server.
For the models which have the PoE or built-in switch network interfaces, the
internal NIC IPv4 address should be configured for the cameras connecting to
the PoE or built-in switch network interface of the NVR.
The valid value range of MTU is 500 ~ 9676.
Click Apply.
Configuring Advanced Settings
Configuring Hik-Connect
Purpose
Hik-Connect provides mobile phone application and platform service to access and
manage your connected devices, which enables you to get a convenient remote
access to the surveillance system.
To Next Page
Loading...
