Network Video Recorder User Manual
56
Chapter 5 Recording Settings
Configuring Parameters
Purpose:
By configuring the parameters you can define the parameters which affect the image
quality, such as the transmission stream type, the resolution and so on.
Before you start:
Make sure that the HDD has already been installed. If not, please install a HDD
and initialize it. (Menu > HDD > General)
HDD- General
Check the storage mode of the HDD.
6) Click Advanced to check the storage mode of the HDD.
7) If the HDD mode is Quota, please set the maximum record capacity For
detailed information, see Chapter 10.2 Configuring Quota Mode.
Go to Menu > Record > Parameters
Recording Parameters
Parameters Setting for Recording
1) Select Record to configure. You can configure the stream type, the
resolution, and other parameters on your demand.
Enable H.264+ Mode: check the checkbox to enable. Once enabled, the Max. Bitrate
Mode, Max. Bitrate(Kbps) and Max. Bitrate Range Recommend are not
To Next Page
Loading...
