HIKVISION HWN-2100H Series - Calling Linear Scan; One-Touch Park

Network Video Recorder User Manual
52
The speed dome starts linear scan from the left limit to the right limit, and you must
set the left limit on the left side of the right limit, as well the angle from the left limit
to the right limit should be no more than 180º.
Calling Linear Scan
Before operating this function, make sure the connected camera supports the linear
scan and is in HIKVISION protocol.
Purpose:
Follow the procedure to call the linear scan in the predefined scan range.
Click PTZ in the lower-right corner of the PTZ setting interface;
Or press the PTZ button on the front panel or click the PTZ Control icon in
the quick setting bar to enter the PTZ setting menu in live view mode.
Click the button to show the one-touch function of the PTZ control.
PTZ Panel - One-touch
Click Linear Scan to start the linear scan and click the Linear Scan button again to
stop it.
You can click Restore to clear the defined left limit and right limit data and the
dome needs to reboot to make settings take effect.
One-touch Park
Before operating this function, make sure the connected camera supports the linear
scan and is in HIKVISION protocol.
Purpose: