Network Video Recorder User Manual
137
Click Upgrade to start upgrading.
After the upgrading is complete, reboot the NVR to activate the new firmware.
Restoring Default Settings
Go to Menu > Maintenance > Default.
Restore Defaults
Select the restoring type from the following three options.
Restore Defaults: Restore all parameters, except the network (including IP address,
subnet mask, gateway, MTU, NIC working mode, default route, server port, etc.) and
user account parameters, to the factory default settings.
Factory Defaults: Restore all parameters to the factory default settings.
Restore to Inactive: Restore the device to the inactive status.
Click the OK button to restore the default settings.
The device will reboot automatically after restoring to the default settings.
To Next Page
Loading...
