Network Video Recorder User Manual
55
Editing IP Cameras Connected to the PoE Interfaces
This chapter is only applicable for the models with PoE interfaces.
The PoE interfaces enables the NVR system to pass electrical power safely, along with data, on
Ethernet cabling to the connected network cameras.
Up to 4 network cameras can be connected to /4P models, 8 network cameras to /8P models, and
16 network cameras to /16P models. If you disable the PoE interface, you can also connect to the
online network cameras. And the PoE interface supports the Plug-and-Play function.
Before you start:
Connect the network cameras via the PoE interfaces.
Enter the Camera Management interface.
Menu> Camera> IP Camera
List of Connected Cameras
The cameras connecting to the PoE interface cannot be deleted in this menu.
Click the button, and select the Adding Method in the drop-down list.
• Plug-and-Play: It means that the camera is connected to the PoE interface, so in this case,
the parameters of the camera can’t be edited. The IP address of the camera can only be
edited in the Network Configuration interface, see Chapter 11.1 Configuring General
Settings for detailed information.
To Next Page
Loading...
Need help?
General
