Network Video Recorder User Manual
36
The PoE interfaces enables the NVR system to pass electrical power safely, along with
data, on Ethernet cabling to the connected network cameras.
Up to 4 network cameras can be connected to /4P models, and 8 network cameras to
/8P models. If you disable the PoE interface, you can also connect to the online
network cameras. And the PoE interface supports the Plug-and-Play function.
To add Cameras for NVR supporting PoE function:
Before you start:
Connect the network cameras via the PoE interfaces.
Go to Menu> Camera> Camera.
List of Connected Cameras
The cameras connecting to the PoE interface cannot be deleted in this menu.
Click the button, and select the Adding Method in the drop-down list.
Plug-and-Play: It means that the camera is connected to the PoE interface,
so in this case, the parameters of the camera can’t be edited. The IP
address of the camera can only be edited in the Network Configuration
interface, see Chapter 11.1 Configuring General Settings for detailed
information.
To Next Page
Loading...
