Network Video Recorder User Manual
62
Configure Motion Detection
1) Choose camera you want to configure.
2) Check the checkbox after Enable Motion Detection.
3) Drag and draw the area for motion detection by mouse. If you want to set
the motion detection for all the area shot by the camera, click Full Screen.
To clear the motion detection area, click Clear.
By default, the feature of Dynamic Analysis for Motion is enabled. When the motion
detection triggered frame (green) for the moving targets in the motion detection
area will be displayed on the live video.
Motion Detection- Mask
4) Click Settings, and the message box for channel information pop up.
Motion Detection Handling
5) Select the channels which you want the motion detection event to trigger
recording.
6) Click Apply to save the settings.
7) Click OK to back to the upper level menu.
8) Exit the Motion Detection menu.
To Next Page
Loading...
