HIKVISION iDS-7200AHQHI-M Series - Region Entrance Detection

7. Set the arming schedule. Refer to
Congure Arming Schedule .
8. Set linkage acons. Refer to Congure Linkage Acons .
9. Click Apply.
4.3.5 Region Entrance Detecon
Region entrance detecon detects objects that enter a predened virtual region.
Steps
1. Go to System Management → Event
Sengs → Smart Event .
2. Click Region Entrance Detecon.
Figure 4-9 Region Entrance Detecon
3. Select a camera.
4. Check Enable Region Entrance
Detecon.
5. Oponal: Check Save VCA Picture to save the captured pictures of region entrance detecon
pictures.
6. Set detecon rules and detecon areas.
1) Select Arming Region. Up to 4 regions are selectable.
2) Set
Sensivity. The higher the value is, the easier the detecon alarm will be triggered. Its
range is [0-100].
3) Click Draw Region, and draw a quadrilateral in the preview window.
7. Set the arming schedule. Refer to
Congure Arming Schedule .
8. Set linkage
acons. Refer to Congure Linkage Acons .
9. Click Apply.
ATM Digital Video Recorder User Manual
41