HIKVISION iDS-7200AHQHI-M Series - Serial Port Protocol; Custom Protocol Settings; Configure Data Package

Steps
1. Go to System → ATM
Sengs .
2. Check Enable ATM.
3. Select Input as Network Protocol.
4.
Set Intercepon Port. The intercepon port is 10000 by default.
5. Select a protocol.
6. Click Apply.
8.4 Serial Port Protocol
The
transacon informaon, including transacon card No, transacon amount, transacon
behaviour, etc., will be sent from the ATM to the device.
Before You Start
Connect the device and the ATM (Automac Teller Machine) via the serial port properly.
Steps
1. Go to System → ATM
Sengs .
2. Check Enable ATM.
3. Select Input as Serial Port Protocol.
4. Set Protocol, Baud Rate, Data Bit, etc.
5. Click Apply.
8.5 Custom Protocol
Sengs
8.5.1 Congure Data Package
The start/end tag can be set to locate the data package in the captured message. You can also lter
the specied content as your desire.
Steps
1. Click Data Package.
ATM Digital Video Recorder User Manual
67