Hill-Rom Isolette C2000 - Alarm Messages

Alarms
Chapter 2: Troubleshooting Procedures
silenced for up to 15 min. Procedural Silence Mode is terminated if a High
Temperature, Airflow, or Probe alarm occurs.
Alarm Messages
The alarm and system prompt messages that replace the Trend Display or the
oxygen and humidity displays during an alarm condition or procedure are
presented in table 2-1 on page 2-16, table 2-2 on page 2-18, table 2-3 on page
2-20, table 2-4 on page 2-21, table 2-5 on page 2-21, and table 2-6 on page 2-
22.
In the event that two or more alarms occur simultaneously, or one after the
other, the messages that describe the alarms will be presented in sequence. A
total of five messages can be posted.
For an explanation of system alarms, refer to table 2-1 on page 2-16.
Table 2-1. System Alarms
Alarm Description
Power Failure A flashing alarm indicator appears with a
continuous audible alarm to indicate that primary
power to the incubator fails, or the power cord is
unplugged from its power source. To silence this
alarm for 15 min, press the Silence/Reset key.
Plug the power cord into an appropriate power
source.
Motor Failed
A flashing alarm indicator appears with a
continuous audible alarm to indicate a motor
malfunction. Turn the incubator off, and remove it
from service (refer to procedure 4.6).
EEPROM failed
A flashing alarm indicator appears with a
continuous audible alarm to indicate an internal
malfunction. Turn the incubator off, and remove it
from service.
Heater failure 1 and 2 A flashing alarm indicator appears with a
continuous audible alarm to indicate a heater
malfunction. Turn the incubator off, and remove it
from service.
Controller failure 1
through 14
A flashing alarm indicator appears with a
continuous audible alarm to indicate an internal
malfunction. Turn the incubator off, and remove it
from service (refer to procedure 4.1).
Page 2 - 16 Isolette® Infant Incubator Service Manual (man223rf)