Hill-Rom Isolette C2000 - Final Actions

Final Actions
Chapter 2: Troubleshooting Procedures
Yes No
y -> The oxygen concentration level is too high. Go to RAP 2,5.
32. Check the humidity system accessory (if applicable).
a. Fill the reservoir, and place the probe of a calibrated hygrometer inside
the hood (A) at the center mattress (L).
b. Pre-warm the incubator to 95°F (35°C).
On Display 1, press the Humidity softkey.
d. Turn on the humidity. Set the humidity setpoint to 50%.
e. Within 30 min to 60 min, the hygrometer and Humidity display reads
50% + 6%.
Yes No |
y > GotoRAP 2.1.
33. Go to “Final Actions” on page 2-14. | |
Final Actions
1. Complete the required preventive maintenance procedures. See
"Preventive Maintenance Checklist” on page 6-8.
2. Complete all required administrative tasks.
Page 2-14 Isolette® infant Incubator Service Manual (man223r1)