F30 03 4 Start-up
HI 800 473 E Rev. 1.00 Page 31 of 46
4.3.1.6 Tab: Mirroring
Mirroring is used to configure whether the module should duplicate Ethernet packets on a
given port such that they can be read from a device connected to that port, e.g., for test
purposes.
The following parameters define how a given port should work:
Off This port does not participate to the mirroring process.
Egress: Outgoing data of this port are duplicated.
Ingress/Egress: Incoming and outgoing data of this port are duplicated.
Dest Port: This port is used to send duplicated data.
Default setting: OFF
4.3.2 Communication Module
The communication module (COM) contains the Module tab and the Routings tab. Their
content is identical to those of the processor module, see
Table 19 and Table 20.
4.3.3 Parameters and Error Codes for the Inputs and Outputs
The following tables specify the system parameters that can be read and set for the inputs
and outputs, including the corresponding error codes.
In the user program, the error codes can be read using the variables assigned within the
logic.
The error codes can also be displayed in SILworX.
To Next Page
Loading...
Need help?
General
