HIMA HIQuad X - Table 18: Operating System States, States Entered

System Product Description
HI 803 211 E Rev. 1.01.00 Page 55 of 110
State
Description
The state is entered:
LOCKED
The processor module is reset to
the factory settings (SRS,
network settings, etc.).
Connecting the supply voltage to the processor
module while the mode switch is set to Init.
STOP/VALID
CONFIGURATION
Processor module stopped: A
valid configuration is available in
the memory.
Stopping the processor module using SILworX.
Applying the supply voltage
 Autostart is disabled in the project
configuration or
 Mode switch is set to Stop and the
processor module starts by itself.
A fault occurred.
STOP/INVALID
CONFIGURATION
Processor module stopped: No
valid configuration is available in
the memory.
Loading with error.
STOP/LOADING OS
Processor module stopped: The
operating system is loaded in the
non-volatile memory.
Loading the operating system using SILworX.
RUN
The user program is running.
From the STOP/VALID CONFIGURATION
state: SILworX command.
Applying the supply voltage, the following
conditions must be met:
 A valid project configuration is loaded.
 Autostart is enabled in the project
configuration.
 The mode switch is not set to Init.
 The mode switch is set to Run if the
processor module starts by itself.
RUN/UP STOP
The user program is not running.
This state is used for testing the
inputs/outputs and
communication.
From the STOP/VALID CONFIGURATION
state: SILworX command SILworX.
Table 18: Operating System States, States Entered