HIMA HIQuad X - Table 29: Parameters for User Groups in the PES User Management

System Programming
HI 803 211 E Rev. 1.01.00 Page 87 of 110
Parameters for PES User Accounts
When editing PES user accounts, the following parameters can be defined:
Parameters
Description
PES
PES name (resource); automatically filled in!
User Group
User group name used to log in to a controller; automatically filled in!
PADT Security Administrator
Password
Field for entering the PADT security administrator password.
Access Mode
The access modes define the rights allocated to users.
The following access modes are possible:
 Read: Users may only read information but they cannot modify the
controller.
 Read + Operator: Similar to Read, but users may also:
- Start, stop and test user programs.
- Configure the redundancy for processor modules.
- Reset cycle time and fault statistics.
- Set the system time, restart and reset the modules.
- Start system operation for processor modules.
- Forcing
 Read + Write: Similar to Read + Operator, but users may also:
- Load the programs into the controller (by performing a download or
reload).
- Perform forcing.
- Change system parameters, such as watchdog time, online.
 Administrator: Similar to Read + Write, but users may also:
- Load operating systems.
At least one user must have administrator rights, otherwise the controller
settings are not accepted.
PES Password
Password assigned to the PES user group and required for login.
The password must not contain more than 32 characters and may only be
composed of letters (A…Z, a…z), numbers (0…9) and the special
characters underscore «_» and hyphen «-».
The entry is case sensitive.
Confirm PES Password
Repeat the password to confirm the entry.
Table 29: Parameters for User Groups in the PES User Management