19
―――――――――――――――――――――――――――
Chapter 3 Measurement Procedures
――――――――――――――――――――――――
DANGER
Never apply voltage to the test leads when a
current measurement function is selected.
Doing so may damage the product and result in
personal injury.
To avoid electrical accidents, remove power
from the circuit before connecting the test
leads.
WARNING
To prevent electrical accidents, do not use the
tester to measure current when the electric
potential is 600 V or greater. The current
function overload protection trips at either 600
V DC, 600 V rms.
3.5 Current Measurement
To Next Page
Loading...
