Hioki PW3336 - Page 198

Appendix 3 Rack Mounting
A12
Installation procedure
1
Remove the feet from the bottom of the instrument, and the screws from the sides (four near
the front).
2
Installing the spacers on both sides of the instrument, affix the rack mounting plate with the
M4 × 10 mm screws.
M4 × 6 mm
M3
× 6 mm
When installing into the rack, reinforce the installation with a commercially available support
stand.
M4 × 10 mm
Spacers
Rack Mounting Plate (EIA)
M4 × 10 mm
Spacers
Rack Mounting Plate (JIS)