3.2 Configuring Settings
45
Display of integration elapsed time
Display of frequency measurements
SYNC. ERROR
See: "3.2.6 Setting the Frequency Measurement
Range" (p.53)
If a warning lamp or “o.r” is displayed
PEAK OVER
See: "3.11 When PEAK OVER, o.r, or the Unit
Indicator Flashes" (p.114)
HRM ERROR
See: "3.4.4 About the HRM ERROR lamp" (p.77)
over-range
See: "3.11 When PEAK OVER, o.r, or the
Unit Indicator Flashes" (p.114)
From 0 sec. to 99 hr. 59 min. 59 sec. From 100 hr. to 999 hr. 59 min.
From 1,000 hr. to 9,999 hr. 59 min.
10,000 hr.
Because measured values become difficult to read near the point at which the display switches, the resolu-
tion is lowered by one digit.
Example: When changing from 1.0000 kHz to 999 Hz, values that would have been displayed as 999.00 Hz
will be shown as 0.9990 kHz. When the frequency falls to 990 Hz or below, the display will switch
to 990.00 Hz.
See: Specifications - Frequency measurement (p.143)
From 0.1000 Hz to 9.9999 Hz From 10 Hz to 99.999 Hz
From 100 Hz to 999.99 Hz
From 1 kHz to 9.9999 kHz
From 10 kHz to 99.999 kHz
From 100 kHz to 220 kHz
To Next Page
Loading...
