Hioki PW8001-11 - Setting the GP-IB Address; Resetting the Remote Control

174
Connecting and Setting the GP-IB
GP-IB connection
Recommended cable:
9151-02 GP-IB Connection Cable (2 m)
About GP-IB
• IEEE-488-2 1987 common commands (required) may be used.
• The interface complies with the following reference standard: (Applicable standard: IEEE-488.1
1987*
1
)
• The interface has been designed based on the following reference standard. (Reference
standard: IEEE-488.2 1987*
2
)
For details, see the Communications Command Instruction Manual.
*1: ANSI/IEEE Standard 488.1-1987, IEEE Standard Digital Interface for Programmable Instrumentation
(ANSI/IEEE Standard 488.1-1987. IEEE Standard Digital Interface for Programmable Instrumentation)
*2: ANSI/IEEE Standard 488.2-1987, IEEE Standard Codes, Formats, Protocols, and Common Commands
(ANSI/IEEE Standard 488.2-1987. IEEE Standard Codes, Formats, Protocols, and Common
Commands)
Setting the GP-IB address
Set the GP-IB address before using the GP-IB interface.
Display screen [SYSTEM] > [COM]
11
1
Tap the [Address] box, then enter the
address on the numeric keypad.
0 to 30
Resetting the remote control
Pressing the REMOTE/LOCAL key while the REMOTE/LOCAL key stays is lit up can reset the
remote control.
Key status
(Lit up in red)
Remote control (remote operation) underway
Keys other than the REMOTE/LOCAL key cannot be operated.
(O󰀨)
Key operation is available.
HIOKI PW8001A961-00