235
Troubleshooting
Issue Cause
Solution and where to nd
additional information
The data I saved includes
one or more large values that
exceed the range.
An overload condition occurs. Set an appropriate range.
See “4.1 Waveform Display Method”
(p. 95) and “7.8 Measured Value
Save Data Format” (p. 137).
The instrument cannot detect a
USB ash drive.
The USB ash memory is broken.
Press the reload button (
) on the
[FILE] screen. Cycle the instrument.
If the cause of your problem remains unclear
If you are unsure of the cause, try a system reset.
All settings will be returned to their factory defaults.
See “6 System Settings” (p. 115).
Maintenance and Service
To Next Page
Loading...
