Hirschmann BAT series User Manual

58
Installation BAT
Release 05 03/2013
2.18.3 BAT-Rail
In the BAT-Rail, the reset button (see (1) in the following figure) is located on
the front plate of the device.
Figure 20: Reset button on BAT-Rail
2.19 Basic set-up
Information on the basic settings of the device can be found in the ”User
Manual Basic Configuration” on the CD/DVD.
 Default settings
You will find information on the delivery state of the device in the "Dual-
Band Industrial Access Point / Client / Access Bridge BAT54-Rail" user
manual.
 V.24 interface (external management)
At the V.24 connection, a serial interface is provided for the local
connection of an external management station (VT100 terminal or PC
with corresponding terminal emulation) or an AutoConfiguration Adapter
ACA 11. This enables you to set up a connection to the Command Line
Interface (CLI) and to the system monitor.
Caution!
Available as an accessory for certain Hirschmann devices,
the AutoConfiguration Adapter ACA21-M12 is not designed to
be used with BAT-F devices.
If you do not adhere to this warning, the ACA21-M12 could be destroyed.
Use the ACA11-M12 if you want to use an AutoConfiguration
Adapter for your BAT-F.
B
AT
5
4-R
a
i
l
A
ux
2
1

Hirschmann BAT series Specifications

General

Brand	Hirschmann
Model	BAT series
Category	Wireless Access Point
Language	English