Network Load Control
140
8.3
Rate Limiter
Basic Configuration
Release
6.0
07/2010
Setting options per port:
X "Ingress Packet Types" allows you to select the packet type for
which the limit is to apply:
X All, limits the total inbound data volume at this port.
X BC, limits the broadcast packets received at this port.
X BC + MC, limits broadcast packets and Multicast packets
received at this port.
X BC + MC + uUC, limits broadcast packets, Multicast packets,
and unknown Unicast packets received at this port.
X Ingress Limiter Rate for the inbound packet type selected:
X = 0, no ingress limit at this port.
X > 0, maximum inbound traffic rate in kbit/s that can be received
at this port.
X Egress Limiter Rate for broadcast packets:
X = 0, no rate limit for outbound broadcast packets at this port.
X > 0, maximum number of outbound broadcasts per second that
can be sent at this port.
X Egress Limiter Rate for the entire data stream:
X = 0, no rate limit for outbound data stream at this port.
X > 0, maximum outbound transmission rate in kbit/s sent at this
port.
Figure 36: Rate Limiter
To Next Page
Loading...
Need help?
General
