Entering the IP Parameters
36
2.3
Entering the IP Parameters via Hi-
Discovery
Basic Configuration
Release
6.0
07/2010
2.3 Entering the IP Parameters
via HiDiscovery
The HiDiscovery protocol enables you to assign IP parameters to the device
via the Ethernet.
You can easily configure other parameters via the Web-based interface (see
the "Web-based Interface" reference manual).
Install the HiDiscovery software on your PC. The software is on the CD
supplied with the device.
To install it, you start the installation program on the CD.
Note: The installation of HiDiscovery includes the installation of the software
package WinPcap Version 3.1.
If an earlier version of WinPcap is on the PC, the follow the suggestion in the
set-up to uninstall it.
A newer version remains intact during the installationHiDiscovery. However,
this cannot be guaranteed for all future versions of WinPcap. In the event that
the installation of HiDiscovery has overwritten a newer version of WinPcap,
you uninstall WinPcap 3.1 and then re-install the new version.
Start the HiDiscovery program.
To Next Page
Loading...
Need help?
General
