EasyManua.ls Logo

Hirschmann MACH 100

Hirschmann MACH 100
294 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Entering the IP Parameters
Basic Configuration
Release
6.0
07/2010
2.5
System configuration via BOOTP
45
Note: The loading process started by DHCP/BOOTP (see on page 218
“Setting up a DHCP/BOOTP Server“) shows the selection of "from URL &
save locally" in the "Load" frame. If you get an error message when saving a
configuration, this could be due to an active loading process. DHCP/BOOTP
only finishes a loading process when a valid configuration has been loaded.
If DHCP/BOOTP does not find a valid configuration, then finish the loading
process by loading the local configuration in the "Load" frame.

Table of Contents

Other manuals for Hirschmann MACH 100

Related product manuals