Entering the IP Parameters
Basic Configuration
Release
6.0
07/2010
2.8
Web-based IP Configuration
51
Enter the parameters on the right according to the selected mode.
You enter the name applicable to the DHCP protocol in the “Name” line in
the system dialog of the Web-based interface.
The “VLAN” frame enables you to assign a VLAN to the agent. If you enter
0 here as the VLAN ID (not included in the VLAN standard version), the
agent will then be accessible from all VLANs.
The HiDiscovery protocol allows you to allocate an IP address to the
device on the basis of its MAC address. Activate the HiDiscovery protocol
if you want to allocate an IP address to the device from your PC with the
enclosed HiDiscovery software (state on delivery: operation “on”, access
“read-write”).
Note: Save the settings so that you will still have the entries after a restart
(see on page 53 “Loading/saving settings“).
To Next Page
Loading...
Need help?
General
