Installation MACH1000
Release
06
03/2021
49
2.5 Operating the device
When you connect the supply voltage, you start up the device.
2.6 Connecting data cables
You can connect end devices and other segments to the device ports using
twisted pair cables or optical fibers (F/O).
Note the following general recommendations for data cable connections in
environments with high electrical interference levels:
Keep the length of the data cables as short as possible.
Use optical data cables for the data transmission between the buildings.
When using copper cables, provide a sufficient separation between the
power supply cables and the data cables. Ideally, install the cables in
separate cable channels.
Verify that power supply cables and data cables do not run parallel over
longer distances. To reduce inductive coupling, verify that the power
supply cables and data cables cross at a 90° angle.
Use shielded data cables for gigabit transmission via copper cables, for
example SF/UTP cables according to ISO/IEC 11801. Exclusively use
shielded data cables to meet EMC requirements according to EN 50121-
4 and marine applications.
Connect the data cables according to your requirements.
See “Ethernet ports” on page 30.
2.6.1 Twisted Pair ports
Connect the data cables according to your requirements.
See “10/100/1000 Mbit/s twisted pair port” on page 30.
See “10/100 Mbit/s twisted pair port” on page 31.
2.6.2 Optical fiber ports
Verify that you connect LH ports only with LH ports, SX ports only with SX
ports, and LX ports only with LX ports.
Connect the data cables according to your requirements.
See “1000 Mbit/s F/O port” on page 31.
See “100 Mbit/s F/O port” on page 31.
See “10 Mbit/s F/O port” on page 32.
To Next Page
Loading...
Need help?
General
