Attached figure4-2-6
1 steering column tube
2. Bearing
3. central axis of the steering shaft
4. Spline
1、Inspect the central axis of the steering shaft whether
flexible and moves.If does,dismantle and checke the
axis,bearing and retaining ring whether ware or
damaged,according to the inspection situation to instead the
parts.
2.Checke the two ends of the spline on the central axis whether
is wear out,if so,instead the central axis.
3、Checke the spline in the tow ends of the central axis whether
have wear,if dose,instead the central axis.
4、Inspect the steering column tube and welding line of the
branch whether have crack and corrosion,if it does,instead
the steering column tube
4.1.1.5Dismantle the steering drive axle
1、Loose the clamp bolt in the cross gimbal, internal spline
on the top of the steering drive axle,pull out the top of
To Next Page
Loading...
