bridge middle transmission shaft cover anchor ear
4.4.1 Disassembly, inspection, assembly of front bridge
components(Reference the front bridge assembly,the figure of
the front box parts).
4.4.1.1Preparation for disassembly and maintenance of front
bridge components.
1.。Check if the connection between wheel hub and conical
nuts is reliable wth no loosen.
2、If there is any distortion on the front wheel hub,the
wheel hub must be replaced immediately.
3. Whether the spare part does coordinate with the sheep
horn,whethe the sheep horn bearing exists stagnation,shake and
noise,if bearing is unreliable,must disassemble the front
bridge
assembly(refer to the front bridge assembly,the figure of the
front box parts),then instead the bearing to use.Checke the
sheep horn whether have rupture,if so ,instead it.
4.Whether the constant velocity cardan joint does coordinate,
to be correct to the position; If is not correct or the
coordination is not
good causes to the position hits the tooth and the
different sound,
To Next Page
Loading...
