must dismantle it, installs and driving agine after the
position correct.
5. Check if there exists any slip thread on the
open-groove nut.
6. Disassemble the front bridge transmission box parts,checke
each joggle whether contraposition and right,the joggle have
no intervene.
7. Whether the oil nozzle does stop up, if so, first to use the
needle to poke the materia,l If it will not be able to solved,
replace the oil nozzle to install the
original position of the front box .
8. If there is any problems with the sensor,it must be
inspected and maintained by the special serviceman.
9. The gear is easy to wear out,and it is in the
transmission system.
4.1.2 Disassemble,inspection and assembly of the front bridge
4.4.2.1 Disassemble the front bridge
1. Take down the left and right front wheel parts.
2. Sequently remove the front disk brake clip,cotter
pin,open-groove nut,cushion and front wheel hub.
3、Disassembe the left and right arm rocker and cross
steering knuckle.
To Next Page
Loading...
