No. Item Description
Default
Value
Supported
LPAR
manager
Version
T: Received all packets.
VLANID: Displays the defined VLAN ID. See
Table 7-18 VLAN ID on page 7-46.
Inter-LPAR Packet filtering: Displays the
inter-LPAR packet filter.
Disable: Inter-LPAR packets are transferred
inside LPAR manager; but not transferred
outside LPAR manager.
Enable: Inter LPAR packets are transferred
outside LPAR manager, but not inside LPAR
manager.
Disable (ALL): Inter-LPAR packets are
transferred to both inside and outside LPAR
manager.
[LPAR manager firmware version 01-9X or
later]
TXRATE: Sets a limited transmission
bandwidth of VF NIC.
Inter-LPAR
Packet
Filtering:
Disable
TXRATE:
10000Mbp
s
Others: -
(8) Function
Key
Displays the function keys that can be used
in this screen.
F2: Displays the list of assigned VLAN ID.
F5: Used to set the promiscuous mode.
F6: Used to change MAC addresses.
F7: Used to set the VLAN mode.
F8: Used for setting Inter-LPAR Packet
Filtering.
LPAR manager firmware version 01-9X or
later
F9: Sets a limited transmission
bandwidth of VF NIC by a 100 Mbps in
the range 100Mbps to 10000Mbps.
- 01-0X~
Table 7-18 VLAN ID
VLAN Mode VLAN ID
Tagged Up to 16 IDs from 1 to 4094, or All (IDs)
Only "All" (all ID) can be specified when VF NIC is assigned.
Untagged One ID from 1 to 4094.
The following table describes each operation on this screen.
7-46
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
