How to change the NTP configuration display
Place the cursor on Setting or NTP at the lower left side and press Enter to
display a sub-screen for selecting the NTP configuration. Place the cursor on
the item to display and press Enter.
How to import the NTP configuration
Note:
• Check that there are no problems with Automatic Time Synchronization to
be imported before importing from the management module or BMC.
• When import source of NTP configuration is set to the management
module, only the setting value of NTP server 1 and 2 are imported to the
LPAR manager. (The setting value of NTP server 2 and 3 are ignored.)
• Only Hour part of TimeZone which was imported from the NTP server is
valid on the LPAR manager. (Minutes part is ignored on the LPAR
manager)
• Not supporting summer time configuration.
Date and time screen is displayed below after the LPAR manager imported
NTP configuration from the management module.
Table 7-33 Date and Time Screen Information
Item
Date and Time screen
Import
Config
Time
Sync
NTP
Server 1
NTP
Server
2
Management
module time
setting
Automatic Time
Synchronization
Enable SVP NTP NTP
Server 0
NTP
Server 1
Disable SVP Disable NTP
Server 0
NTP
Server 1
BMC
time
setting
Time
Synchronization
Method
Synchronize time with
the Management-
Modules by using NTP.
BMC SVP None None
Synchronize time with
the Management-
Modules by command or
manual.
BMC Disable None None
• Place the cursor on Import Config at the lower left side and press Enter
to display a sub-screen. Place the cursor on the item to import and press
Enter.
7-94
Operation by LPAR manager Screen
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
