Message Content
LP-Loader could not find VfcSeed.dat in management
module.
What to do The switching N+M t might be failed, check the BSM error. When
there is no error, Contact the reseller from which you purchased
this equipment or consult maintenance personnel.
Message Content LP-Loader could not update OEM FRU.
Explanation Updating the Vfc seed information to FRU failed when the N+M
was performed.
What to do There is a possibility that the BMC error occurred or FRU data is
damaged.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Message Content
LP-Loader detected a value of Emulex NIC(Bus:0xXX)
Personality unsupported for this LP. Please reset Emulex
NIC Personality to a value supported for the LP.
XX: Bus number
Explanation LPAR manager cannot start because a value not supported by
LPAR manager is set for the Personality for Emulex NIC.
What to do Set a value supported by LPAR manager for the Personality.
For details about setting the value, see the Hitachi Compute Blade
Emulex Adapter User's Guide for Hardware.
Note that this value cannot be changed in LP mode. If necessary,
change the value in Basic mode.
Message Content
LP-Loader detected configuration error in management
path portX, [Code:X SlotType:XX BladeNo:XX SlotNo:XX
PortNo:XX].
Explanation A configuration error in the management path was detected.
What to do Check whether there are any problems in the management path
configuration and settings.
Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
Message Content
LP-Loader detected an unsupported NIC. (Bus:0xXX, Dev:
0xYY, Fnc:0xZZ) Please Power Off Partition.
XX: Bus number
YY: Device number
ZZ: Function Number
Explanation An unsupported NIC is detected. So, the LPAR manager boot is
suppressed.
What to do Contact the reseller from which you purchased this equipment or
consult maintenance personnel.
9-6
Messages
Hitachi Compute Blade 500 Series Logical partitioning manager User's Guide
To Next Page
Loading...
